hello, welcome to guangzhou qingqin yu official website!
NEWS
News
Contact Us
Guangzhou Qing Qin Yu Environmental Protection Technology Co., Ltd.
Sales Center: Room 1010, South Tower, Xindacheng Plaza, 27 Erheng Road, Shuiyin Road, Yuexiu District, Guangzhou
Fax: 020-38989166
Metech Multifunctional Fault Condition Analysis O2 Code
Release time:
2023-11-10 16:41
This type of failure occurs as follows:
1. The ground is extremely uneven, creating significant resistance for the millstone and placing excessive load on the motor.
2. If this occurs when using the new machine for the first time, it means the governor has already been adjusted to the fastest speed setting, or the new grinding discs (or blocks) may be involved.
The unopened rough material is pressed onto a coarse, hard surface, creating significant resistance on the grinding disc and placing excessive load on the motor.
3. If, after gearbox body repair, the initial test run shows this issue, it could indicate that the gears were not assembled smoothly or are too tight, causing the grinding disc to rotate manually with difficulty.
None of them are smooth; or during assembly, after the motor is secured, the motor shaft becomes misaligned with the central gear—resulting in off-center rotation—and this causes electricity...
The rotor's rotation is obstructed, resulting in jerking.
Corresponding solutions:
1. Lift the machine and move it to a relatively smooth area for grinding, then slowly approach particularly uneven ground areas—or alternatively, use
Other small grinding machines will slightly smooth and level the uneven, rough surface of the ground, followed by finishing with this machine.
2. Roughly grind the grinding disc (or block) on the cement floor. Press down firmly on the handle frame, then lift the machine slightly off the ground (so the grinding wheel is just above the surface), and start the motor.
Simply lower the machine (grinding wheel) slowly to the ground.
3. Reassemble the gears or reattach the motor to ensure smooth rotation of the gears and grinding disc. After inserting the motor shaft into the central gear, align it properly with the gear.
With the motor and housing securely suspended, power up the motor to smoothly set the motor, gears, and grinding disc in motion. After shutting down, use your hand
Just keep the millstone turning smoothly.
Previous Page
Previous Page
Related News
WeChat Public Number
Business Contact
WeChat Public Number
Business Contact
Copyright©2023 Guangzhou Qing Qin Yu Environmental Protection Technology Co., Ltd.
