NEWS

News

Contact Us

Guangzhou Qing Qin Yu Environmental Protection Technology Co., Ltd.


Sales Center: Room 1010, South Tower, Xindacheng Plaza, 27 Erheng Road, Shuiyin Road, Yuexiu District, Guangzhou



Fax: 020-38989166





Meuse pulse airflow industrial vacuum cleaner performance indicators

Release time:

2023-11-10 16:50

The pulsed air flow is directly injected into the filter cartridge without passing through the Venturi. will cause the filter cartridge to approachPulse valveOne end (upper part) of the filter cartridge will bear negative pressure, while the other end (lower part) of the filter cartridge will bear pressure. This will cause the upper and lower parts of the filter cartridge to be different, which may shorten the service life and make the equipment unable to achieve effective cleaning.
For this purpose, a Venturi for the filter cartridge can be installed at the pulse valve outlet or on the pulse nozzle.Nozzle. The distribution of the injection pressure is improved to a more uniform full filter cartridge height positive pressure injection.
Dust accumulation in the folding seam of the filter cartridge will make cleaning more difficult. Therefore, a filter cartridge with a large folding area (each filter cartridge has a filtration area of 20 to 22 m2) is generally only suitable for use in the case of lower inlet concentrations.
Cartridge dust collectorThe gas distribution box of the pulse blowing device shall meet the requirements of JB/T 10191-2000. Clean air flow should be free of water, oil and dust. Pulse valve under the specified conditions, the injection valve and interface should be no leakage, and can be opened and closed normally, reliable.
pulse controllerThe work should be accurate and reliable, and the blowing time and interval can be adjusted within a certain range. When the induction blowing device is installed with the blowing pipe. The nozzle of the induction blowing device shall be coaxial with the nozzle hole on the nozzle pipe, and keep the same verticality with the nozzle, and the deviation shall be less than 2mm.

Related News