CASES

Application Case

Contact Us

Guangzhou Qing Qin Yu Environmental Protection Technology Co., Ltd.


Sales Center: Room 1010, South Tower, Xindacheng Plaza, 27 Erheng Road, Shuiyin Road, Yuexiu District, Guangzhou



Fax: 020-38989166





Meitengqi Multi-function Failure Analysis o2 Code

Release time:

2023-02-23 09:20

This type of fault occurs as follows:
 
1. The ground is very uneven, the resistance of the grinding disc is large, and the motor load is too heavy.
2. If this situation occurs when the new machine is used for the first time, it means that the governor has been adjusted to the fastest speed position, or the new grinding plate (block)
Not open rough pressure on the rough hard surface, resulting in a large disc resistance, motor load is too heavy.
3. If the gearbox is repaired and the machine is initially tested like this, it may be that the gear assembly is not smooth and too tight, causing the grinding disc to rotate manually.
It is not smooth, or the motor shaft and the center gear are not concentric after the motor is fixed during assembly, that is, the rotation is not concentric, which makes the electricity
The rotation of the rotor is blocked and Caton occurs.
Corresponding solution:
1, the machine up, move to a relatively flat ground area grinding, and then slowly cut into the uneven ground area, or use
Other small grinding disc machinery will ground the rough surface of the potholes slightly smooth, and then use the machine to grind.
2. Roughen the grinding piece (block) on the cement floor. Press down on the armrest and raise the starter of the machine (make the grinding disc slightly off the ground).
The machine (grinding disc) can be slowly landed.
3. Reassemble the gear or reassemble the motor to make the gear and the grinding disc rotate smoothly. After inserting the motor shaft into the central gear
Concentric, suspend the motor and the box and energize the motor to start the motor, so that the motor, gear and grinding disc rotate smoothly. After shutdown, hand
Rotate the grinding disc smoothly.