CASES

Application Case

Contact Us

Guangzhou Qing Qin Yu Environmental Protection Technology Co., Ltd.


Sales Center: Room 1010, South Tower, Xindacheng Plaza, 27 Erheng Road, Shuiyin Road, Yuexiu District, Guangzhou



Fax: 020-38989166





Analysis of Common Faults of Sparing Machine and Summary of Solutions

Release time:

2023-10-16 18:03

1. Smoke from the smoothing machine when working

Check the trowel machine to check whether there is too much oil. If there is too much oil, release part of it. It can also be that the piston is broken and severely worn and will burn the oil. If it is damaged, it needs to be replaced in time. Check the engine. If the engine is not faulty, it may also be that there are too many impurities in the oil. The oil is very important. Try to choose high-quality oil. When buying, you must pay attention to prevent buying inferior fake oil.

2. How to level the chassis screws of the smoothing machine

First replace 4 new blades and put the trowel in a particularly flat place. Then remove the shift fork and visually inspect whether the heights of the four screws are consistent. If conditions permit, measure them with a ruler. If the heights are inconsistent, adjust them to be consistent. When the gland is gently shaken, if there is no shaking, the debugging is proved successful. Put some butter on the top of the screw to prevent wear.

3. The wiping machine always stalls

Observe whether the oil level is normal and whether the oil is too little. Some machines have their own oil protection system, which will automatically turn off when there is a shortage of oil. There is also the fact that after the remote flameout switch and the flameout switch of the machine are disconnected one by one, if the flameout phenomenon does not occur again, it means that there is grounding in that part. Just check and eliminate it carefully.

4. The engine of the trowel is normal, but the trowel is not moved.

If there is no problem with the engine, it is caused by the wrong belt type or the belt is too long. If there is still an abnormality, it can be handled by changing a clutch.

5. The gasoline polish machine was blistered

First clean the carburetor, let the spark plug be removed to see if there is water in the cylinder head. If there is water, pull the disk several times to drain the water. Try again after changing the oil to see if it is normal.

6. The smoothing machine cannot rotate

Reason: The blade may be deformed; the motor bearing is broken; the motor bracket is not fixed well; there is a problem in use.